SURFACE FOR USE

Ensure substrates to be applied are sound, clean, free of grease, oil, dust deposits and others contamination. Wet all dry and porous substrates with clean water before application.

MIXING

Mix the product thoroughly with approximately 10% by weight of clean water using an electric mixer with attached stirrer for 3 – 5 minutes, until a homogeneous mix is achieved.

APPLICATION

Pour onto surfaces, use either wood or steel trowel to trowel to the desired thickness and finish.

Each layer of screed applied should not exceed more than 30mm thickness. More than one coat can be applied if necessary

FIRE RESISTANCE

This product is non-combustible.

SAFETY PRECAUTIONS

This product contains cement additives and may cause irritation when in contact with skin or eyes. In case of any contact, wash thoroughly with clean water. If irritation persists, seek immediate medical attention.

DISCLAIMER

All information contained herein is only intended to give a fair description of the products and their capabilities under such specific test conditions.
However, it does not constitute an offer of warranty by the manufacturer nor a guarantee of its accuracy or completeness in describing the performance or suitability of the various products.